What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 14:30

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
These devices are installed between the “hot” and “neutral” and protective ground.
eight
RBC Canadian Open Odds, Picks, Predictions: Best Bets, Props, OAD - Lineups
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
He then describes the function of a fuse.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
the problem then depends on "how fast does the fuse operate?".
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Can you explain the difference between “mi piace” and “mi piacciono” in Italian?
One is “what exactly is in a ‘surge protector’ ? ”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
The third is lightning and “how it gets conducted into a home.”
At one ohm, the resistor has a maximum of 1 watt power.
what exactly is a ‘surge’ protector?
a photo is worth a thousand words.
35 Father’s Day Gifts For Anyone Who Still Doesn’t Know What The Heck To Get Their Dad - BuzzFeed
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The bolt then partially travels down the line to your home.
How AI chatbots keep you chatting - TechCrunch
A circuit breaker is similar, but is resettable.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Here is a simplified AC power diagram.
What causes you to be tired all the time and major headaches?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
There are three different concepts here that are getting confused.
A fuse is a non-resetable over current circuit protector.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
New rabies cases detected in SLO County. How to avoid deadly disease - San Luis Obispo Tribune
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Sorting Out Long COVID Symptoms in Babies - Medscape
This is where the MOV conducts again, and dissipated the energy.
What does a fuse do?
but this device (an Inductor) … impedes the rapid changes in the current.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
There are two important concepts here.
[image of Common-mode choke]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Upvotes:
It also is a device that limits the change in current flow.
(Dc diagram shown, AC is similar).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
So, the voltage could go up to 500 volts, and the fuse will not open up.
This is where this question deviates from being a 'generic' question, and becomes more specific.
[old diagram got deleted by accident]
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
but I think this circuit , shows a few more pieces.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–10[John johnson John Johnson ]
Now when you have a certain ac resistance, then a current flows in a loop.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Edit 2024–10.
This one hit behind the barn.
But it can get overloaded, and no longer works.
What is lightning?
This device then solves the entire problem.
He then asserts :
I post the exact comment here.
2024–10–16 [ OO OLAOYE OYEBODE ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
The other is “what does a “fuse” do?”
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
For this case there are devices called Metal oxide varistors (MOV).
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
An AC voltage/ current source, and an ac inductive load.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
nine
It seems Mohan does not understand the difference between a comment and an Answer.
In schematic diagrams this is the symbol for a fuse:
First Sentence:
This is 'the assistant's answer'
He then describes Rainy Season and Lightning.
But… the neutral is now “floating” because of the 1 ohm resistance.
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
so, what happens?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
One
At least they know the answer if they wanted it.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Barnstars:
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Because the load is inductive, the current lags the voltage.(by a bit).
“ A fuse is a device which protects the (circuit) against overload and short circuit.”